would be useful and convenient, the insertion of doors and windows, automatic folding of the layers, do not believe it but with Revit Architecture this is not science fiction! Let's see a practical case: the coat. I start with a simple wall, formed by an inner layer of brick and the outer coat, on which I put a window.
As you can see the coat does not revolve around the opening formed by the insertion of the casing, a change is a must for the wall. In fact, simply set the parameter as Exterior Fold inserts.
now revolves around opening up the coat but not quite correctly. In fact, the layer stops approximately half-wall, but it should get close to the window.
The error, as obvious conclusion, but the software is not in the family of the window. The edited so as to affix the frame along a particular plane of reference or a reference "does not reference" with the flag enabled on wall closure.
Reloading the family changed ...
... et voila! Now the coat runs correctly!
Enjoy!
0 comments:
Post a Comment